A while back we published an article All about above ground pools and after that we received numerous requests to make an article on how to make a DIY pool deck around above ground pool and finally, here it is. Above ground pools are great and cheap but if you want to take pool experience to the next level you need a place for sunbathing and relaxation next to the pool. Most of people think that building DIY pool deck is to complicated task for them but it really isn’t. It’s a large project in scale but it’s not difficult to make and doesn’t require professional skills. All you need is good lumber, basic woodworking skills and some time. The size of the deck is determined by the size of your pool and your personal wishes. Once again, the principal for small and large deck is the same, only differences are in amount of materials and labor.The first thing in any DIY pool deck project is clearing the ground where your future deck will be. Strip all the grass and around 2 inches of dirt where your construction site will be. For the posts we used 4 x 4 lumber and we advise you not to use smaller lumber than that. First take four boards and setup the future look of your deck on the ground. Use that to mark the spots for the posts and remove the boards. Use a post hole digger to dig up holes slightly bigger than the posts. Make sure that your holes are deep enough and that they are below the frost line, at least 3.5 ft. Set the posts in the holes, level them and start to fill the holes with rocks. Once you’re half way there use four larger rocks and secure the post on each side. Then fill up the rest of the hole with rocks. You can also use concrete but this method will be solid also. Don’t forget to protect the part of the post which goes into the ground with waterproof wood sealant because otherwise the posts will rot in the ground. After all the posts are in place it’s time to start with the frame. For the beams and joists we used 2 x 6 boards and we advise you to not to used smaller lumber than that. Before you start with the frame, take four pieces of 2 x 4 and use them to temporary secure and level the corner posts. After you screw in the beams you don’t need them anymore and you can remove them. Your beams need to be perfectly leveled and it’s hard to achieve that if both ends of the beam are loose. Use a small piece of wood and temporary screw it to the post below the selected height of the beam and place one end of the beam on it. That way you’re aligning only one end of the beam and you’ll see it’s much easier to level the beam this way. The three outside beams must be the same height and the one near the pool will be 6 inches below. The main frame is now done and you can now secure all the posts and put weed barrier and stone below your future deck. We advise you to do that now because after the deck is finished it’s hard to crawl under it.